By Elizabeth Harris
Supplies needed:
Envelope Punch Board (EPB)
Bone Folder
Adhesive
Paper Trimmer
Designer Series Paper (DSP)
1. You will need 3 strips of DSP: 1” X 6”, 1” X 4” and 1/4” X 1 1/4”.
2. Line up the end of the 6” strip at the 3” mark on the EPB and punch. Flip and repeat.
3. Line up the ends of the 6” strip at the wall of the punch mechanism on the EPB and punch. Flip and repeat on all 4 sides.
4. Curl with your bone folder. Using your favorite adhesive, attach ends to middle of bow.
5. Wrap 1/4” X 1 1/4” strip to middle of bow and attach using your favorite adhesive.
6. Line up the end of the 4” strip at the 2” mark on the EPB and punch. Flip and repeat.
7. Center ends of 4” strip in center of punch mechanism and punch. Flip and repeat. Attach to bottom of bow with your favorite adhesive.
The final result!
The blue bow’s tail is using a 1” X 3 1/2” strip instead of 1” X 4” strip.
Play around with different size strips and see what you can create!
Have fun!
You can see more of Elizabeth's creations at her blog.
EMHar720@verizon.net
Cute!
ReplyDeleteThey look great!!!! I think this might just sell more "Envelope Boards", also
ReplyDelete